Options
Vacuum / Gas Flush Options
- Multi-Stage: up to two vacuum and two gas cycles, to achieve lower residual oxygen level
- Vacuum Level Sensor: ensures consistent vacuum levels are achieved every cycle
- Vacuum Relief Valve: sets a maximum vacuum level to prevent product damage
- Venturi Vacuum Pump: for quiet operation and low maintenance
- Nozzle Extend Control: manually extending vacuum nozzles, for bulky bags
- Larger Nozzles: for vacuuming the air out of the bag faster
- Profiled Nozzles: narrow radius on nozzles for more vacuum on thick materials
- Vacuum Reserve Tank: reduces the vacuum time by quickly pulling a high vacuum
Sealing Options
- Bag Stretcher: fingers fit inside edges of the bag to minimize wrinkles in the seal area
- SureTemp Temperature Controller: ensures consistent seal quality (up to 350°F)
- Pressure-evening system for sealing thick or gusseted bags
- Water Cooling: prevents excessive heat build up in the jaws during high speed sealing
- High Pressure Seal: increases seal pressure for heavy materials and gusseted bags
- Extra Seal Power: additional seal transformer for continuous production at high rates
- Seal Only Switch: retracts nozzles for use as a bag sealer (no vacuum)
- Seal Jaw Selector Switch: allows bottom seal jaw to be turned off
- Trim Wire: leaves a finished sealed edge on the bag
- Twin Seals: two parallel 1/8″ seals (one side heat only)
- Bag Stop: allows bag to always be sealed in the same location
Safety Options
- Emergency Stop Button
- Two Stage Cycle Engagement: jaws close by foot pedal, cycle initiated by dual palm buttons
- Locking Control Box Cover: cover on control cabinet to prevent unauthorized setting changes
- Stainless Steel Jaw Covers: placed over the front of the seal bars
- Dual Palm Buttons: prevent operator contact with seal jaws during closure
- Motorized Crank Adjustable Frame: adjust the operating height of the machine for improved ergonomics (12″ travel)
Other Options
- SureSeal Digital Interface: includes 9 program job storage
- Workshelf Bag Support: supports the product during the packaging cycle
- Hot Embosser: up to 8 brass characters 3/8″ above the seal
- Hot Stamp Printer: hot embosser with thermal transfer ribbon
- NEMA Enclosure: isolate electrical and pneumatic components from environmental conditions
- Ported Exhaust: for plumbing exhaust out of a cleanroom
- Stainless Steel Construction: for wet or corrosive environments
- Short Stand (Tabletop): allows machine to be fastened down to a table (requires venturi vacuum)
- Integrated Air Compressor
- 220V Operation
- CE Compliant
- Casters
